GNU/Linux tee command

From WikiOD

tee - read from standard input and write to standard output and files.

The tee command is named after the T-splitter in plumbing, which splits water into two directions and is shaped like an uppercase T.

tee copies data from standard input to each FILE, and also to standard output. In effect, tee duplicates its input, routing it to multiple outputs at once.

Syntax[edit | edit source]

  • tee [OPTION]... [FILE]...

Parameters[edit | edit source]

Options Description
-a, --append Append to the given FILEs. Do not overwrite.
-i, --ignore-interrupts Ignore interrupt signals.
--help Display a help message, and exit.
--version Display version information, and exit.

Remarks[edit | edit source]

If a FILE is specified as a dash ("-"), tee writes again to standard output.

Write output to stdout, and also to a file[edit | edit source]

The following command displays output only on the screen (stdout).

$ ls

The following command writes the output only to the file and not to the screen.

$ ls > file

The following command (with the help of tee command) writes the output both to the screen (stdout) and to the file.

$ ls | tee file

Write output from the middle of a pipe chain to a file and pass it back to the pipe[edit | edit source]

You can also use tee command to store the output of a command in a file and redirect the same output to another command.

The following command will write current crontab entries to a file crontab-backup.txt and pass the crontab entries to sed command, which will do the substituion. After the substitution, it will be added as a new cron job.

$ crontab -l | tee crontab-backup.txt | sed 's/old/new/' | crontab –

write the output to multiple files[edit | edit source]

You can pipe your output to multiple files (including your terminal) by using tee like this:

$ ls | tee file1 file2 file3

Instruct tee command to append to the file[edit | edit source]

By default tee command overwrites the file. You can instruct tee to append to the file using the –a option as shown below.

$ ls | tee –a file

Credit:Stack_Overflow_Documentation